High-Back vs Mid-Back Office Chairs for Streamers and Creators Try both chairs at the mic. Compare where each backrest meets your shoulders, then see how it supports you when you lean back to watch a clip. Jorden Hebenton November 17, 2026 If you're weighing a high-back vs. mid-back office chair, pay attention to what happens when you lean back between segments. A high-back chair is worth trying if you want support higher up your back during those pauses. A mid-back chair can suit an upright stream if its backrest meets you comfortably and leaves room for your shoulders to move. With TwitchCon San Diego wrapped up, try a short recording at your own desk. Talk into the mic the way you would on stream, check chat, then settle back as if you were watching a clip. You might first feel the top edge of the backrest against your shoulder blades when you lean into it. Where does the backrest meet your shoulders? A mid-back office chair usually ends lower on the torso. Depending on your build, its top edge might sit below your shoulder blades or across them. A high-back office chair extends farther up and can support more of your upper back. Ask for the height from the seat to the top of the backrest when you compare specs. The height from the floor includes the base and seat setting. If there's a separate neck pad, check the backrest measurement and the pad's adjustment range. What to check Mid-back office chair High-back office chair Upper-back contact A lower top edge can leave your shoulders clear. Check where the edge lands as you lean into it. A taller backrest can give your upper back more surface to rest against. Check how the sides sit around your shoulders. Fit when you recline Try a shallow lean and check whether you still have enough contact across your back. Lean back to the angle you normally use and check how much support reaches your upper back. Neck contact Check whether the chair has a separate adjustable pad if you want one. Check whether the top of the chair reaches your neck and how far any separate pad can move. Compare seat-to-backrest height and check the neck pad separately. Set the seat height and check that you can sit all the way back with your feet supported. Then see where the backrest meets you. If you slide forward to get room behind your knees, check seat depth before judging the backrest. Our Office Chair Size Guide shows how to check both measurements. Check neck support at the angle you actually use Lean back a little and see where your head settles. If the chair has an adjustable pad, bring it into light contact and face your main screen. If the pad pushes your head forward, try moving it back. Try a different height if it presses against your headphones or sits so low it meets your shoulders. Now come back up to the mic. You may prefer to have space behind your head while you talk and contact when you recline. Check whether the chair gives you both at a setting you can use without reaching behind yourself every time. The CSA Group's chair setup guide recommends checking backrest fit in several seated positions, including how it supports your shoulders when you lean back. Check where the neck support meets you while you recline with your headphones on. Record a short test before you decide Read your usual opening out loud, then bring up chat. Turn as far as you normally do to check the feed. On a broad, high backrest, see if the side edge catches your upper arm. On a mid-back chair, notice if the top edge digs in when you turn and settle back. Repeat that move a few times. An edge you barely notice while facing the camera can get in the way when you check chat every few minutes. Play the recording back and listen for changes in your voice level as you sit up and lean back. If you keep moving toward the mic between sentences, bring the boom arm closer and try again. If you have to hold a turn to read chat, move that window closer to your main screen. See our desk setup guide for creators and editors for screen placement. Sit up at the mic and check whether you can speak at a comfortable distance. Compare how each chair supports the move back to the mic To try Dynamic Ergonomics on the LiberNovo Omni Pro, lean back from your usual on-camera position. The flexible panels and pivot points in the Bionic FlexFit Backrest let it change shape as you move. Dynamic Support links the seat, backrest, and armrests so they move together. Adjust the Neck Support to see where it meets you when you lean back, then sit up and see where your arms land as you reach for the controls. Use the last minute of your trial to watch a clip. If both chairs feel good while you're upright, that pause can settle the choice. Notice which backrest you naturally lean into and whether you can come back to the mic in one easy shift. If you can, try an ordinary session before you decide. A quick trial can show you where a backrest lands. A full stream gives you time to feel how often you actually use it. Explore LiberNovo Omni Pro Back to blog Share on Facebook Opens in a new window. Tweet on Twitter Opens in a new window.